Further investigation: The OUT POWER is low, only around 10uV or -70dBm,
way too low for analysis ... no wonder the calibration won't return
sensible results. So...can the tech folks here point towards the output
amp? I can replace it, but would prefer schematics etc before diving in?
:)

Regards, Rod.

>
> Same here, RF calibration just returns a lot of noise!?
>
> Rod.
>
>
>> I flashed new FW and cal'd touch.
>>
>> This is what it looks like after cal with and without load.
>>
>>
>>
>>
>>
>>
>
>
> --
> =================================
>
> Mitchell Electronics
> 73 Fiveash Drive
> Pasadena SA 5042
>
> ph: 08 8276 2939
> mob: 0409 099 299
>
> ABN: 42 570 486 022
>
> =================================
>
>
>
>
>
>
>


--
=================================

Mitchell Electronics
73 Fiveash Drive
Pasadena SA 5042

ph: 08 8276 2939
mob: 0409 099 299

ABN: 42 570 486 022

=================================