WA2TP 2021/10/29 14:25

Have had the VNA2 Plus 4 for almost a year and it had been working fine up until about a week ago.
Then it began to only load the software once and then the software would not work again unless I re downloaded and re installed it.
Now the VNA will not connect at all today. Neither VNA QT or Saver will work, Additionally it appears that the VNA will not work as standalone  either.

I have already re-flashed the dmu with new firmware and still cannot get the unit to work even as standalone.
I cannot perform any sweep at all. Unit appears frozen. Sweep setting is not paused.

Is there any way to full reset the unit an reload software?